StromTrooper banner

Symtec Heated Grips install questions re: EB PC8

1K views 2 replies 2 participants last post by  LowAndSilent 
#1 ·
I've taken a look around but can't find anyone asking/answering these specific questions, probably because most people are more electronically inclined than I am.

I am about to install my Symtec heated grips on my DL650 and had some questions about the wiring. Anyway, here they are:

1) I have an Eastern Beaver PC8 kit. Should I just run the wiring back to it? Would that length of wire cause any issues?

2) What gauge wire would work best? I'm guessing something in the range of 18, but I'm not sure.

3) Can I just take the two ground leads from the two grips and join them together and run them back to the PC8 with just one cable?

Any assistance would be greatly appreciated. Thanks!!
 
#2 ·
It looks like you answered your own questions. Those are good methods.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top