StromTrooper banner
1 - 14 of 14 Posts

·
Until we meet again
Joined
·
5,436 Posts
Discussion Starter · #1 ·
Recently I was the lucky winner of a photo contest sponsored by SV Racing Parts. The prize was a SuperBrace for my DL1000. I was pretty happy about that because I had been curious about the brace, but not curious enough to spend the money on one. In the past I've installed other "must have" upgrades for bikes and been very disappointed. Progressive fork springs for my KLR 650 come to mind. I didn't feel any change and believe I wasted my money on that one. To be honest I was wondering if the SuperBrace would be the same situation. I'll admit to low expectations.

I've always been very happy with the handling of my stock Vee. Compared to my old DL650 it was just as flickable. I never felt it suffered any penalty from the extra weight. I could take it into the harshest of twisties with ease. I even think it handled better that my old FZ1. This satisfaction was the major contributor to my low expectations of the brace. The bike is so good now, how can it get better?

Blair at SV Racing Parts had asked me to write about my experience so I wanted to be fair and really try to give the brace every chance. To start my test I took my pre-brace bike out on a 10 mile loop. Reasonable twisty sections, but nothing too special. Also while riding I was doing some S turns from line to line in my lane. Anything to give me a fresh memory of the handling characteristics of my bike.

Upon returning home I put the bike on the centerstand and installed the brace. Installation is easy with just 4 screws. I did not find the install to be as effortless as I've seen some say. Getting the front piece between the fork and the fender did take some minor muscling to get into place, then the back of the brace slid into place very easily. Tightening the screws was also a very minor challenge. Mainly getting the allen wrench at the correct angle. Do not get the idea installation is difficult, it's not. It's easy to understand and once you get everything into place it's simple. It's just not completely effortless. Takes about 10 minutes.

Back on the bike. To the west and moving fast I see nasty rain clouds coming over the mountain. I'm pretty sure I can make the loop and beat them back to my house. I need to try this brace while I've got the old setup fresh in my brain. I grab the throttle and go. I instantly notice the front end seems tighter. Not sure how else to explain it, just tighter. Next I try my little S turns. The bike responds immediately with a very crips turn. Very interesting. Now rather that doing gentle S turns I start doing short burst left and right handlebar inputs. The new precision is unmistakable. The steering response is instant and exact. There is no "maybe I feel a difference" thought running through my head, it's a very significant change. Next I take my hands off the bars. I was never impressed with my Vee's tracking when hands free. The bike tracked perfectly straight now in hands free mode. Overall the bike seems tighter, is tracking better and more precise.

4 miles from home I realized my gamble failed. I'm now in heavy winds and an absolute downpour of sideways rain. I forgot about the test and concentrated on not getting blown off the road. Conditions became miserable in the distance of about a 1/2 mile As I was reaching home I thought to myself I am so glad I have this brace installed. The extra handling precision was greatly appreciated in those conditions.

Back when I had low expectations I thought I'd ride with it for a while then take it off to see if I could tell the difference. Forget it. There is no way I'm taking this thing off. I'm a believer now. The best way I can describe the difference is to think of a non braced bike as steering using bungee cords stretched to their max extended position. Response is good, but there is some lag time between input and response. A braced bike is like being welded from the handle bars to the front tire. Response is instant and precise. Tracking is straight and it feels like the bike is more solid, almost like riding on rails.

The question is always asked...would you buy it again? Well, I didn't buy it in the first place, so I can answer that one. I can say that if it were stolen I definitely would replace it. There's no guessing about this one. I can tell a significant change in the bike, and I feel more in control with it there.

A word about Blair at SV Racing Parts. Super nice guy. He sent me a DL1000 brace as soon as I won. Unfortunately the brace had been mistakenly miss packaged at the factory and it didn't fit my bike. Blair had me send it back to the factory so they could see their mistake and they were to send me another. Turns out the factory was out of stock and moving locations so it was going to be a while. Although none of this was Blair's fault he repeatedly apologized for the situation. Production took longer than anticipated and Blair was always reassuring me that I would not be forgotten. In the end he was good to his word and the brace arrived this week (and it was packaged right). In the end I'm certain I'll be checking his product line first for the next farkle I need to buy. I liked the way he handled the situation and would definitely trust him again. Plus he's a member here.

Blair's member profile
SV650-Racing-Parts

Couple of shots of the new brace.





 

·
Premium Member
Joined
·
3,735 Posts
I don't have that particular brace on my bike, mine is a K&B, but I completely agree with your assessment. I thought about one for a good while, and then a friend whose opinion I respect highly recommended them so I gave it a try. Pretty much the same impressions. Nothing you can put your finger on and say it specifically does this better, it's just that everything feels more precise. The bungee cord analogy is good because that's really what it feels like. You don't realize it until you add a fork brace, but the increase in responsiveness is certainly noticeable the first time you ride with one on. I also agree that if something happened to mine it would be immediately replaced without a second thought.
 

·
Registered
Joined
·
18,801 Posts
Thanks for sharing and great write up! I also agree with your assesment of having a quality fork brace.
 

·
Premium Member
Joined
·
390 Posts
Dirt Dad,.... pretty amazing transformation from such a simple piece isn't it?
I too was a skeptic,.... but what a believer now. I went about it a little differently though. Where you did back to back comparisons, I had installed the brace but then had to leave on a week long trip. When I returned home I hopped on my bike, forgetting all about the new Superbrace installation. It all fell into place at 120 kph in a strong x-wind. I was much more planted and stable than usual, and couldn't figure out why it felt so different until I remembered I had installed the brace. Wow, what a change! I would also definitely immediately add a fork brace if I had to replace my Strom.
 

·
Registered
Joined
·
645 Posts
Good writeup Dirt_Dad!

I won my Superbrace at the Eastern meet last spring. If I had known how much of an improvement it would make, I would have installed it right then and there instead of waiting until I got home!!
 

·
Until we meet again
Joined
·
5,436 Posts
Discussion Starter · #6 ·
One postscript.

In the past I had read other references to the brace and some people said it made the bike more stable when riding next to a tractor trailer. Since the bike's overall stability was improved that sounds right, but I had this nagging question in my head after the rainy ride I mentioned. I was really fighting hard to stay on the road and at times had a very aggressive lean angle into the wind. I was wondering why I had to work so hard, shouldn't the brace have kept me completely stable? I figured it must have helped, but I wasn't certain just how much.

After getting home and watching news a day later I have a better understanding. The news was showing many massive trees that had fallen on houses and across roads as a result of the storm. The gust were recorded up to 72 MPH. I'm have no idea how fast my crosswinds were, but they were the most vicious I had ever experienced on a bike. Knowing this I think it's unreasonable for me to wonder why the brace didn't keep me perfectly nailed to the center of my lane. Instead I'm glad the brace assisted me in staying between the lines.
 

·
Premium Member
Joined
·
390 Posts
LMAO, picturing Dirt Dad riding dow the road wondering why his new fork brace isn't helping him keep between the yellow lines as trees are uprooted behind him and cows go flying overhead!! "Dadgummit, I thought the fork brace was s'posed to fix this!?" :twisted: Good on ya' DD to put yourself out on the line like that in the name of science!!

Cheers,
 

·
Until we meet again
Joined
·
5,436 Posts
Discussion Starter · #8 ·
LMAO, picturing Dirt Dad riding dow the road wondering why his new fork brace isn't helping him keep between the yellow lines as trees are uprooted behind him and cows go flying overhead!! "Dadgummit, I thought the fork brace was s'posed to fix this!?" :twisted: Good on ya' DD to put yourself out on the line like that in the name of science!!

Cheers,
I'm here to serve :cool:
 

·
Living the Stereotype
Joined
·
11,544 Posts
Glad you made it home

I'm here to serve :cool:
Are you sure you're not also here to swerve?
(sometimes I can't help myself)

Great story, hurricane season is just around the corner, Weather Channel can always use a motorcycle-mounted reporter.
 

·
Vendor
Joined
·
5,008 Posts
SuperBrace is In Stock at SV Racing Parts

Recently I was the lucky winner of a photo contest sponsored by SV Racing Parts. The prize was a SuperBrace for my DL1000. I was pretty happy about that because I had been curious about the brace, but not curious enough to spend the money on one.

A word about Blair at SV Racing Parts. Super nice guy. He sent me a DL1000 brace as soon as I won. Unfortunately the brace had been mistakenly miss packaged at the factory and it didn't fit my bike. Blair had me send it back to the factory so they could see their mistake and they were to send me another. Turns out the factory was out of stock and moving locations so it was going to be a while.

Although none of this was Blair's fault he repeatedly apologized for the situation. Production took longer than anticipated and Blair was always reassuring me that I would not be forgotten. In the end he was good to his word and the brace arrived this week (and it was packaged right). In the end I'm certain I'll be checking his product line first for the next farkle I need to buy. I liked the way he handled the situation and would definitely trust him again. Plus he's a member here.
:) Thanks Jon for th great write up. I really appreciate it when the contest winners actually post up their real life experiences with the products I put up as prizes.

At the end of the day, I am just another 55 year old who loves motorcycles, and wants everyone to have great parts. I pay for the prizes out of my own pocket, so it is gratifying to know that people appreciate the products.

On another note, I have plenty of DL650 and DL1000 SuperBraces in stock for immediate shipping. The MSRP is $157.95 for this patented Fork Brace Product.

I provide them to my fellow Stromtroopers for 10% off, ($142)and no taxes regardless of where you live, $10 shipping anywhere in the lower 48.

A great price, and a superb patented product, where you can be sure the engineering is right for your bike.

DL1000 Vstrom


DL650 Vstrom

Canadian customers, get 2 day Express Post, No GST, no sales tax, and no border broker fees, $14 in Western Canada, and sorry Eastern Canada, but 2 day express post to you is $20.

They look great and work better.

Thanks, and best regards,
Blair
 

·
Webfoot
Joined
·
851 Posts
Hmmmm....

Adding another bolt-on to my list....

Also, I agree with the comments on Blair. I bought the frame sliders a while back and he was very responsive and prompt with my questions, had good parts at a good price. What more can you ask for?
 

·
Until we meet again
Joined
·
5,436 Posts
Discussion Starter · #12 ·
:) Thanks Jon for th great write up. I really appreciate it when the contest winners actually post up their real life experiences with the products I put up as prizes.

At the end of the day, I am just another 55 year old who loves motorcycles, and wants everyone to have great parts. I pay for the prizes out of my own pocket, so it is gratifying to know that people appreciate the products.
I certainly do appreciate the product. Just got back from putting another 50 miles on the bike. It really is a significant improvement. Thanks again Blair.
 

·
Registered
Joined
·
15 Posts
Getting my own bag full of farkles...

Dirt dad, (and other strominators)

I am glad to hear about the fork brace stories. I just ordered FB, FSprings, Riser and some other thingy-ma-bobs. I am getting my 1k ready for the next trip. Why don't some of us get together for a ride. I am in the outer banks, but will head just about anywhere to meet some other bike freaks. If you remember, I bought the V in Dec. flew to San Diego and rode it back through the ice, snow, rain, wind, sun (oh did I mention WIND) etc etc to the E Coast. It was 3100 miles in 6 days. My first time on a Dual Sport...it was great. I have done trips like that several times on cruisers and big road bikes, but never had been on a DS in my life. What a wonderful motorcycle. LETS GO, life is passing us by.
 

·
Until we meet again
Joined
·
5,436 Posts
Discussion Starter · #14 ·
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top