Should there be a boot or a sleeve?

1467 Views 3 Replies 3 Participants Last post by CCamp, 10 mo ago

CCamp

Discussion Starter · 10 mo ago

Recently suffered a bad connection at the harness that caused my low beams to go out, cleaned and reconnected now they are back on...My question is should there be a boot or sleeve over those two connectors on the harness that runs down the clutch side of my 03 DL1000? I think I read or saw something about other models have one.

1 - 4 of 4 Posts

PeteW

· #2 · 10 mo ago

There should be a rubber/plastic hood slides down over them and at least stops rain and splashes hitting them directly.

Reactions: 1

Recumbentbob

· #3 · 10 mo ago

Make one or use electrical tape.

Reactions: 1

CCamp

Discussion Starter · #4 · 10 mo ago

Thanks guys, I was thinking about an old bicycle innertube to make one...funny how parts just disappear over time.

1 - 4 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.