StromTrooper banner
1 - 1 of 6 Posts

· Registered
578 Posts
I went the cheap route and used "Tusk" brand risers from Rocky Mountain ATV/MC yesterday. Also removed hose from the loop and it is tight. I may try both moving master cylinder a bit and attempting to rotate the banjo fitting so the hose is pointing down to relieve some strain. I suspect it will work as is, bit I'd rather relieve some strain on the hose if possible. Mine is a 2011 650 (with ABS of course).

1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.