StromTrooper banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
258 Posts
Discussion Starter #1
The external diameter is less than the stock bars so I have a couple of loose controls even after cinching down the appropriate screws/nuts. How have others addressed this issue? I was thinking of using a couple wraps of golf grip tape. Any other ideas?
 

·
Registered
Joined
·
797 Posts
A single layer of electrical tape did the trick for me. Anything more than 1 layer was too much.
 

·
Premium Member
Joined
·
258 Posts
Discussion Starter #3
I tried a layer of electrical tape but it wasn't enough. Maybe I'll just try another layer before going the grip tape route.
 
1 - 3 of 3 Posts
Top