StromTrooper banner

Installing Galfer brake lines on a 2008 DL650A: a couple of questions

761 12
I'm elbow deep in replacing the brake lines on my 2008 DL650A. I've come up with a couple of questions that I hope the community might give me some clues on.

1 - The kit includes some short (about 6") lines that run from the ABS block (at the triple tree) back to the front ends of the rigid lines that go all the way back to the ABS control unit. When I look in from the front, it sure looks like I'll have to remove the tank to access the rear ends of those 6" lines. Any suggestions or tricks for me here, or do I just bite the bullet? I'll attach some photos, progressively zooming in to the connections.
I asked Richland Rick, and he said that he thought it was not necessary to remove the tank, but also added that the 2008 was different from the years just after (or before?) it, so he wasn't sure.

2- The three way splitter block that was attached to the left fork has a bolt that also helps hold the fender to the fork. With the splitter block gone (the new hoses use a different splitter connection), the bolt will be way too long. I was just going to buy a shorter bolt. Am I missing something here?

Thanks for any help.
Motor vehicle Automotive tire Automotive lighting Hood Helmet

View from in front of the bike

Motor vehicle Automotive tire Hood Automotive design Automotive exterior

Moved in closer

Snake Automotive tire Reptile Scaled reptile Wood

Zoomed way in. That's the original ABS brake hose coming in from the left, and the connection in question way the heck back in there.
1 - 4 of 4 Posts

·
Registered
Joined
·
242 Posts
Discussion Starter · #4 ·
It takes maybe 15 minutes to pull the tank. Why skin your knuckles?
Too late, already skinned them on half a dozen other things [emoji16]

But yes, I expect I'll pull the tank.

However I'm also learning that the connections for the rear brake may be worse. [emoji47]

Sent from my Pixel 6 using Tapatalk
 

·
Registered
Joined
·
242 Posts
Discussion Starter · #6 ·
I don't recall the rear brake line being particularly difficult. I'd recommend getting the special wrench to remove/install the line nuts. I tried using a regular wrench and almost rounded the brake line nut which would have been a disaster. Pic below.

Also, be sure to replace the heat shield because the rear brake line is so close to the rear exhaust header. See this link California Winter Project

View attachment 309968
Thanks. I spent quite a while getting the battery holder out, to get access to the ABS unit connections, and then quit for the day.
Did you have to remove the battery holder on your bike?

I'll look into those wrenches.

Sent from my Pixel 6 using Tapatalk
 

·
Registered
Joined
·
242 Posts
Discussion Starter · #8 ·
I aim replace my brake lines next year when I replace my coolant and air filter. Will have everything stripped off the bike to do them.
I don't have tiny oriental hands[emoji16]
Does your bike have ABS? If not, then at least the front brake should be easy. Also, I get the impression that it's different for different model years.

Sent from my Pixel 6 using Tapatalk
 
1 - 4 of 4 Posts
Top