StromTrooper banner

1 - 3 of 3 Posts

·
Registered
Joined
·
202 Posts
Discussion Starter #1
I picked up a marine fuse block a few months ago and I'm ready to tackle installing it. I'd like it to be "switched" with the ignition, rather than hard-wired to the battery (to prevent parasitic drain on the battery when the bike's not running). I'm planning to run the positive cable through a relay to the battery, and close the circuit using a relay that's switched with the ignition.

Seems straightforward, and I'm sure a number of folks have done similar - which brings me to my question. Is there a sticky or a decent thread somewhere which shows how to do this? I'd love to have a guide. I've searched around the forum on various terms but haven't discovered anything yet.

Pointers or advice appreciated.
 

·
FORUM GODFATHER.....R.I.P. PAT
Joined
·
38,047 Posts
1 - 3 of 3 Posts
Top