StromTrooper banner

Fork mounted lights

9771 Views 27 Replies 16 Participants Last post by  rubenz
For Conspicuosity. I have searched the threads, want to have more triangular light print than putting them on the light bar under the headlights, looked at the reflector boss - 5 mm bolt, the fender mount - 6 mm bolt, plus the possibility of crushing the fender mount tab when tightening. Then I saw the axle is hollow. What would be wrong with running a 5/16th or 3/8th bolt all the way through and mounting the LED's on the ends? What am i missing, besides adding to unsprung weight?
1 - 1 of 28 Posts
Here is the write up I did on my fork mounted lights.

http://www.stromtrooper.com/general-v-strom-discussion/46958-driving-lights-again.html

I did these just to be seen...so far so good.
1 - 1 of 28 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top