StromTrooper banner

Excessive rear brake pad wear - wear pattern on piston - caliper rebuild?

2311 Views 15 Replies 9 Participants Last post by  strom_r0m
Hello internet,

yesterday I noticed my rear brake pads being completely worn out at 44000 km. Last time I checked at 35000 km and they were fine. The brakes were dragging a bit at that point so I cleaned the caliper and pistons and did all the sliding pin maintenance. The brakes were still slightly dragging afterwards but the rotor didn't feel hot to the touch so I left it at that. I can't tell if that has changed in the meantime.

I don't use my rear brake much and don't rest my foot on it. I recently filed down the rear brake push rod at 42000 km to lower the brake pedal (see this thread: Rear brake pedal adjustment bottoming out after foot peg...) and tested the brake pedal forcefully on several occasions.

Today I took the caliper apart and noticed wear on the piston on one side only.

Sculpture Art Wood Artifact Statue
Automotive tire Sculpture Artifact Art Statue

Automotive tire Bumper Automotive exterior Gas Auto part

pads good at 35000 km
Bottle Eyewear Audio equipment Event Fashion accessory
Automotive tire Audio equipment Font Material property Gauge

Top Piston seal bit dirty but looks ok, bottom seal seems fine too
Automotive tire Tire Motor vehicle Rim Automotive exhaust

Oooops, I wish I hadn't pushed it back in.....
Food Tableware Liquid Drinkware Beer

brake fluid from the calliper quite dark, last flush 8 month ago
Wood Gas Tints and shades Close-up Metal

Only in the photo the damage was obvious to me, just looking at it I could easily have mistaken it for some stubborn crud
Gas Auto part Wood Metal Household hardware

opposite side looks better, just some very hard to remove crud?

Couple questions:

Did the piston get stuck and could only move back on one side which caused the damage? I'm trying to understand the mechanics of it...

Could my modification to the push rod have anything to do with it?

How likely is the piston responsible for my woes?

Could I be ok using the old piston and new pads and just see if the rotor gets hot?

I'm going on a 6000km trip to Greece soon. I'd be happy if anyone could share their experience with brake and piston wear...

Thanks!

Attachments

1 - 1 of 1 Posts

· Registered
Joined
·
5,543 Posts
I don't have that wear problem but I do tear the brakes down and clean them now and then. So the 2x wear one side isn't an "They all do that problem", most likely it's the slide pin has grooves in it as well OR the anti-rattle springs are in the wrong place or missing. You can buy replacement pins.

Yeah, new piston at least and it may be worth just getting a new rear caliper instead.
 
1 - 1 of 1 Posts
Top