StromTrooper banner

Ended up being a Trivalve Sunday

1K views 7 replies 4 participants last post by  Pauloxxi 
#1 ·
So finally got around on checking in on the valves just short of 21K.
Bike is a daily highway commuter and does around 90miles a day.

all intakes were fine, 3 of the exhaust valves were tight. All three exhaust valves had 1.68 shims installed from the factory.

Fellow board member Joey borrowed my kit some weeks ago and did his valves. Not sure what his numbers were but I ran out of 1,6 shims and used 2x 1,6 and 1x 1,55 shims to get the job completed.


Paper shows 1,65 but should read 1,60 :fineprint:

Rest of the entire album can be seen here:
Vstrom Valve BSK - Album on Imgur
 
See less See more
1
#3 ·
Ja det ging ganz gut mit dem Cockpit ausm weg. 2 Bolzen und 3 Kabel und schwupps!
Hauh wech die Scheisse!

 
#5 ·
Ich dachte immer hier sind nur Ammis..
 
#7 ·
Haha. My shims were all .172-.175 from thr factory. All four of my exhaust valves were too tight. One being at .012.. whoops!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top