StromTrooper banner

1 - 1 of 1 Posts

·
Registered
Joined
·
45 Posts
Discussion Starter #1
I made a pair of lowering linkages for my Wee when I upgraded to an R1200GS.... hoping my wife would ride it. The process is incredibly complicated and I doubt you fine folks could keep up.... but I'll try to explain what I did.

Bar is 1/4"x1" steel flat bar. Holes are 6" apart on center and 0.5" diameter with 1/4" of steel on either side. Overall length is 7". Attached below are pictures of the sexiness...likely to be cleaned up if we decide they're the right length.


Sent from my SM-G920V using Tapatalk
 
1 - 1 of 1 Posts
Top