StromTrooper banner
1 - 10 of 10 Posts

· Registered
Joined
·
75 Posts
Discussion Starter · #1 ·
I bought a center stand from another member which came with the springs and mounting plates, but without the hardware (Nuts and Bolts).

Anyone know where I can get the specs for these or order them?
Thanks,
Mike
 

· Registered
Joined
·
1,959 Posts
Hey look, I remembered.

1 - M8, 45mm
1 - M8, 35mm
2 - M10, 35mm
2 - M10, 45mm

Doesn't say what the thread pitch is, however. 1 or 1.5 I suppose? You'll have to verify.

Good luck.
 

· Registered
Joined
·
3,861 Posts
Hey look, I remembered.

1 - M8, 45mm
1 - M8, 35mm
2 - M10, 35mm
2 - M10, 45mm

Doesn't say what the thread pitch is, however. 1 or 1.5 I suppose? You'll have to verify.

Good luck.
The thread pitch for both the M8 and M10 fasteners will be 1.25mm.

In M8, this is standard. In M10, this is considered a "fine" thread.

Any real hardware store (hint: not bLowes, Meantard's, or Home Desperate) should be able to fix you up with high-grade goodies.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top