StromTrooper banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,846 Posts
Discussion Starter #1 (Edited)
Installed my auxiliary shelf this weekend with power socket, Datel voltmeter and driving light switch. Had an extra hole for a future switch and decided to put in a panel mount fuse for the lights and socket. If you didn't know better, you would think it was from the factory. Very pleased. One installation tip is to route the wiring back through the forks before going to different points on the bike - that seems to reduce the movement of the wiring at the shelf, and therefore the wires rubbing on on other parts.
 

·
Vendor
Joined
·
4,912 Posts
IMPORTANT NOTE: I make all the custom shelves myself. I will be attending the eastern V-Strom agthering, touring Florida, and slowly meandering back to WA state during the month of April. So no custom shelves will be made during this period. We will have a few blank shelves and shelves with two cigarette style power sockets pre-cut ready to go. You can contact the office at 509-521-7040 for availability. You are welcome to make an order, but expect delivery of any custom shelf orders to not occur until mid June.

Our other products will be shipped out promptly despite my absence. I guess they really don't need me around here that much after all. YEA! :thumbup:
 
1 - 2 of 2 Posts
Top