StromTrooper banner
1 - 5 of 5 Posts

· Registered
Joined
·
5 Posts
Discussion Starter · #1 · (Edited)
I have read what I could find ( thanks to all of you ) and I have jumped the wires and turned on the key but it only reads " check ". No codes or dash marks. Am I doing something wrong? Does the bike have to be running? Is there and order that I should go in ? TPS - TBS - Secondaries ???? Thanks again
 

· FORUM GODFATHER.....R.I.P. PAT
Joined
·
38,702 Posts
CHEC usually indicates the kill switch not in the run position or the side stand down with the bike in gear.
 

· FORUM GODFATHER.....R.I.P. PAT
Joined
·
38,702 Posts
FAQ: Dealer Mode & FI Error Codes
C13 Intake Air Pressure Sensor (IAPS)
C21 Intake Air Temp. Sensor (IATS)
The typical situation is the air box was put back on and the sensors were not plugged back in.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top