StromTrooper banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 9 Results
  1. DL1050 from 2020 - ?
    So I searched through the forums and wasn't able to find enough information to take a stab at it, but I bought some adventure boots for ankle protection and I can't get my foot under the gear shifter. I know it is possible to adjust it, but what I saw on YouTube isn't quite the same as what I'm...
  2. DL650A - 2017+
    Hi all, wasn't quite sure where to post this - my question is specifically in relation to any potential changes to the 2017+ 650's for a valve adjustment, so went with the 2017+ forum, but I obviously understand it's a maintenance question. There are posts abound regarding valve adjustments...
  3. Suspension and Tire Tech
    I would like to be able to adjust the rear preload to fit my needs (switching between solo and 2-up). However, my dial won't turn at all. Well, maybe 1/300th of a degree. Has anyone had this issue? If so, what can I do to get that baby spinning again? Previous owner said he had it set at 5. I am...
  4. General V-Strom Discussion
    I noticed a chain adjustment was due and it was to be the first one I have done since I purchased my '09 Wee. (No I did not buy it in 2009 LOL) The local independent dealer completed this task for me last time while the motorcycle was in for another repair. When I broke the axle nut loose and...
  5. DL650A - 2012-2016
    Hello all, I am looking for pictures of mods to the seat on 2013 650. Please post what you have. Also, What's a clean method for cutting pads? Thanks!
  6. DL650A - 2012-2016
    Hi everyone. I bought a 2012 Wee a couple of weeks ago, and I'm at 900 miles. I thought it was time to inspect the chain tension and it looked like there was just under 2" of movement. With the manual's guidance I adjusted the chain, but now there is a loud hum that's especially noticeable as I...
  7. DL650A - 2012-2016
    Clutch lever friction point? Hi, First service complete and my dealer adjusted the clutch. The friction point is now just before the clutch is fully released. After a 40 min ride through traffic, I found it really annoying. At the same time, the bike feels a bit smother. So the question...
  8. DL650 and DL650A - 2004 to 2011
    Its time for my valve adjustment. Actually its past time! Anybody close to WNC that would be willing to show me how and got the tools it would be appreciated. Never done it, got the manual and it probably aint that hard but an experienced hand would be nice. Let me know. RR
1-8 of 9 Results