|Topic Review (Newest First)|
|03-23-2015 10:39 AM|
Had one, took it off
Had one on my 08 Wee. Took up so much grip space and just couldn't get used to it so I took it off. Then i tried putting in on my DR and didn't like it there either. I made a throttle lock out of a piece of wire, it works OK, not as good at holding the throttle as the one that fits over the grip, but takes up little space. Vista looks like it would be a good set up, I'm goin to try the Go Cruise. Might want to sell the over grip throttle lock (forget the name of it)
|09-01-2014 07:26 PM|
Originally Posted by skysensor View Post
|05-05-2014 02:49 PM|
Originally Posted by greywolf View Post
|09-01-2013 11:44 PM|
|Axl||Have one on mine and love it took a little while to get use to it on the grip but now don't even know its there also have grip puppies on and love the set up|
|09-08-2012 09:25 PM|
|greywolf||I had the NEP CC4 on my '07 and the Universal Vista Cruise on my '05. They both worked well.|
|09-08-2012 09:23 PM|
Originally Posted by David08 View Post
Removed bar end and disconnected outside fingers of OEM hand guard. Removed grip puppy. Installed VC bar clamp. Positioned VC grip ring. Mounted cross bar. Trimmed grip puppy to new length and reinstalled. Reinstalled bar end. Adjusted acorn nut for appropriate hold and release.
|09-08-2012 09:15 PM|
I just installed on my 09'. Piece of cake, had to move nothing. Hardest part of this install was compressing the little sprint on the thumb piece to pass bolt through.
Wish I had put this on earlier.
|09-08-2012 07:24 PM|
Skysensor, Did you use the NEP CC4 that Greywolf mentioned earlier in this post or a different part# I have grip puppies also. I hope they are okay for this installation.
|09-08-2012 06:39 PM|
This is a dead simple install on a 07-11 Wee. Everything worked without modification or use of adapters. You need to use the thicker (rather than thinner) rubber for the stock grip. No cutting. The arm is the perfect length, so you use the shorter bolt without the arm adapter.
I wanted to note, however, that contrary to the OP, I did need to move my mirror/brake in slightly to make room for the bar clamp. As delivered, it was too close to the switch housing. Had to move in perhaps 1/8", though I was able to slide it back out ever so slightly once the lock was installed.
|07-20-2012 12:41 PM|
|greywolf||It's loosen no more than 1/2 inch.|
|This thread has more than 10 replies. Click here to review the whole thread.|