Installing Acerbis Multi concept Handguards

[Switchfoot]

Is there any mods that need to be done prior to installing? I am trying but running into problems with the throttle cables and the brake lever rubbing.

Any help would be greatly appreciated.

Thanks,
Doug

[Rainier_Tom]

On my Vee I installed Acerbis MultiConcept handguards on Maier ATV Woods Pro aluminum barkbusters. No problems.

[Switchfoot]

Thanks for the pics. I see some differences, not sure how much the affect things.

You have a 1000, and looks like you extended your throttle cables, and your brackets are different than mine. The shell is the same.

I will try to use the pics and see if that helps.

Thanks again!

[Rainier_Tom]

Throttle cables and hydraulic lines for the brake and clutch are all stock. I'm also using MSR Dominator ATV high bend aluminum bars.

[longgreensilverado]

look here for clamps that will help with a solution. i have the U-clamps

http://offroad.parts-unlimited.com/1...13?q=u%20clamp

[jddeering]

I have the Acerbis Multi Concept on my 650 with the acerbis brackets. I had to move a few things around a bit, but did not cut or alter anything. I can send pics if youd like.

[Switchfoot]

You have pm.

[Bullet]

Hiya guys,

I'm new here and so is my DL1000 experiance. The previous owner had protaper bars (seven/eights) fitted along with Acerbis Multyconcept hand guards. It looks like in case of a fall the Acerbis mounts mounts could rotate taking out the Clutch/Break lines. This can also bee seen on th epic above.

Is there any experiance on that or am I just imagining BS.

thanks & Cheers

[tmcgee]

[quote=Switchfoot;474318]Is there any mods that need to be done prior to installing? I am trying but running into problems with the throttle cables and the brake lever rubbing./QUOTE]

You might have to rotate/move cables and controls a bit to make everything fit.