Heated Hand Grips on the Cheap

[CHIA]

I just installed the Symtec ATV models on my bike last weekend, and chose to also buy the Easter Beaver 3CS harness, as apposed to OEM connector.

Like some others, I installed mine over the OEM grips, then covered them with Grip Puppies.

Have only tried them in the garage, not riding, but they heat up well, and I'm looking forward to a test ride.

[snoop]

Originally Posted by ggg663

Like to echo Baiku's comments, very slick install with the "euro" switch. Nothing like this on the '05 Wee I'm riding. Regardless, looks very clean and sounded fairly easy.

Thanks for the picks. Anymore advice on installation. I'm looking to install heated grips myself and these may just fit the bill. Thought about Oxford's and some others, but would really like to stay with the original grip size.

Thx!

Its really as easy as it sounds. There are instructions with them to do the install with a little wiring diagram. Shouldnt take more than 2-3 hours in your garage.

[ggg663]

Snoop, thanks! Will be ordering tomorrow. I'm looking forward to riding this winter with warm hands. Awesome!!! Though not exactly Mr. Mechanical, I have done pretty well on the ol' Wee so far. I'll post my success (hopefully) with photos for any other Troopers looking to do the same thing.

Thx again for your help.