Hand Guard Installation

[davesvalk]

Anyone Know Where To Get Nuts And Bolts To Add Guards To Wee . The Stock Once Are To Short . I Can Not Believe That A Basic Nut And Bolt Will Do .

[greywolf]

Did you get the kit and lose a fastener or what?

[jwt]

I put the oem suzuki handguards on the other day, and I just checked the install. Instructions to see if the bolt sizes were listed, unfortunately not. The part # on the oem guards is 57300-27820-291. Perhaps more bolt info is available if you use that number. If they'd have just listed the bolt sizes on the install sheet...oh well. Good luck.

[davesvalk]

Purchased The Guards In This Forum But No Hardware Only Guards

[greywolf]

The hardware is odd sized and shouldered. Buy the kit and use what you have as spares for when you scrape one.

[iron_llama]

Take it to a hardware store and try to match it.

[greywolf]

57300-27821-291 is the new part number. The picture is for a DL1000 so is a little different. 5 and 11 are representative of the hardware. They are shouldered, with tall hex heads and the heads are tapped to receive screws. You won't find those at a hardware store.

http://images.powersportsnetwork.com/fiche/images/Suzuki/2007/Motorcycles/10125_45.gif

[davesvalk]

Thanks Greywolf I Appreciate The Follow Up . Ride Safe