Supporting S/S brake lines

[bill l]

I've got some Galfers to install (650) and have checked out the stock routing. The stockers are very well supported so that no motion is transferred to the banjo fittings (or what ever they're called). The hose rub points are clamped and/or rubber insulated. Has anyone got a trick or two for supporting the new S/S lines? Pics would be even better. I haven't found any using search. If you've got a great set up, here is your chance to show it off! Thanks for any help

[Tollster]

I am at work now, but recall I was able to use the stock bracket on the left side off the fender. The right side was a lttle tricky as one cannot order the left bracket and reverse it to the right side fender mount area.
Instead I ordered the longer left side screw and "Square" nut that fits on the inside fender channel and fabricated a bent hose guide using needle nose pliers. Then I removed all galling with sand paper and emry cloth. I also lined the hose with a piece of small plastice tubing to reduce chaffing when the front suspenion is stroked.
Hope this helps